Papua New Guinea Plastic Composite Outdoor Drainage Net for Protection

Composite Drainage Net is a new type of drainage geosynthetic product, it is made from three-dimension drainage net bonding to needle punched non woven geotextile by one or two sides. Three dimensional composites drainage network consists of a tri-dimension thick vertical rib, and a inclined rip on the top and bottom.

Category:

Papua New GuineaComposite Drainage Net

Phone:+86 13105487610

Product Description

Introduction

Three dimensional composite drainage network is a new type of geosynthetics. Its structure is a three dimensional geonet core, and there are needle punched non woven geotextiles on both sides. The three dimensional geogrid core consists of a thick vertical rib and an inclined rib at the top and bottom, which can rapidly drain the around water from the road. Composite geonet is a new type drainage material. lt has three layers: three-dimensional geonet and nonwoven geotextile on both sides Thematerial of geonet is HDPE. and the material of geotextile can be needle punched PET/PP nonwoven geotextile and thermal bonded continuous filament nonwoven geotextile. It also has a pore maintenance system, which can block capillary water under high load. At the same time, it can also play the role of isolation and foundation reinforcement.

Video Showcase

Applications

Highways: vertical edge-of-carriageway drains intercept the lateral flow of ground water. Modern fin drains reduce excavation, reduce backfill quantities and reduce installation time. In-slope drainage increases geotechnical stability.
Retaining walls and bridge abutments: to reduce pore water pressure and avoid backfill saturation.
Engineered landfills: with the additional requirement of long-term chemical resistance and high compressive strength.
Tunnels: ground-water-seepage interception between rock face and the tunnel lining.
Buried structures: vertical and horizontal drains for basements, culverts, car parks, reservoirs, etc.

Working Drawing

Specifications

Property	unit		BC50/D200	BC63/D200	BC70/D200	BC80/D200	Test Standard
Geocomposite specification
Hydraulic conductivity(MD)	M²/s	2.8×10-3		3.2×10-3	4.0×10²	5×10-3	ASTM D4716
Puncture	KN/m	0.17		0.17	0.17	0.17	ASTM D7005
Resistance	KN/m	0.17		0.17	0.17	0.17	ASTM D7005
Core Material Geonet Specification
Thickness	mm	6.3		7.0	8.0	9.0	ASTM D5199
Density	g/cm³	0.94		0.94	0.94	0.94	ASTM D1505
Carbon Black Content	%	2		2	2	2	ASTM D1603
Tensile strength (MD)	KN/m	8.0		10.0	12.0	14.0	ASTM D7179
Geotextile Specification
Unit weight	g/m2	200		200	200	200	200
Geotextile type		Continuous filament non-woven geotextile